![]() ![]() ![]() Three of the holes were threaded for screws and two were for taper pins to hold the bracket in alignment while it was assembled. Five holes were drilled into the side of the M1C receiver for attachment of the mounting bracket. Both the bracket and mount were developed by the well-known civilian firm of Griffin & Howe. The first design, designated as the “M1E7,” featured a bracket fastened to the left side of the receiver for a telescope mount. Two prototype Garand sniper rifles designed to mount a scope on the left side of the receiver were eventually selected and differed primarily in the configuration and placement of the scope base and mount. Such an offset location required a leather cheek pad be attached to the stock to properly position the shooter’s face, but that was not viewed as a serious detriment. Testing of the several proposed designs for M1 sniper rifles concluded that the best solution would be to mount the telescope on the left side of the receiver so normal functioning of the rifle would be unaffected. Sizeable numbers of ’03A4 sniper rifles were produced and widely issued during the war until a satisfactory Garand sniper rifle could be developed. 30, M1903A4, Snipers” as more or less an interim measure. ![]() While it and other M1 rifle-based sniper designs were evaluated, a slightly modified Remington Model 1903A3 bolt-action rifle was adopted in early 1943 as the “U.S. tested several possible solutions-including a prismatic telescope with the eyepiece centered over the M1’s rear sight but with the body of the scope offset to provide the necessary clearance for the action. Since the M1 had to be loaded from the top, a telescope mounted in such a location would not be feasible. However, it was immediately apparent that the M1 rifle’s action would require an entirely different approach than most bolt-action sniper rifles-which mounted a telescope directly over the receiver. Early in the war, the Army Ground Forces requested that a sniper version of the M1 Garand rifle equipped with a telescopic sight be developed. Army did not have a standardized sniper rifle. At the time of the Pearl Harbor attack, the U.S. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |